Vi, j'ai le dernier firmware
Peut être bin que le WAP est mal configuré. Dans la doc, il supporte ces modes :
• Access point—Select this option to let the device operate as a normal
access point.
- Allow Wireless Signal to be repeated by a repeater—If selected, the
device will act as a repeater for another access point. Provide the MAC
addresses of the other access points in the fields.
• Wireless WDS Repeater—Select this option to let the access point
operates as a wireless repeater to extend the radio range of the associated
remote access point to overcome any obstacle that blocks radio
communication.
- Remote Access Point’s MAC Address—Enter the MAC address of the
remote access point directly, or click the Site Survey button to select
from a list of available access points.
• Wireless WDS Bridge—Select this option to let the access point operates
as a wireless bridge to perform transparent bridging with other associated
wireless bridges, and not allow any wireless client or station to access
them.
- Remote Wireless Bridge’s MAC Address—Enter the MAC addresses
of the other access points in the fields.
• Wireless Client/Repeater—Select this option to let the wireless access
point operate as a client or repeater access point, sending all traffic
received to another access point.
- Allow wireless stations to associate—Enable or disable this setting.
- Remote access point—Enter the MAC address and SSID of the desired
access point or click the Site Survey button to choose the access point
from the available networks.
Je l'ai laissé dans le mode AP, et si j'indique l'adresse MAC du Tplink dans la case "Allow Wireless Signal to be repeated by a repeater", le WDS échoue côté Tplink
Tu aurais sélectionné quel mode ?
