Bonsoir,
J'ai possède un netbook Acer AOD255E depuis un certain temps. Je ne l'utilise que de temps en temps et il me dépannait bien jusqu'à tout récemment ou il n'a plus voulu booter. Après quelques recherche, j'ai trouver une solution pour les cas de BSD sur les Acer Aspire One. Malheureusement, la méthode ne semble pas fonctionner sur le D255E. En utilisant la combinaison de touche indiqué et en plaçant les fichier du BIOS (ceux du D255E pour le coup) sur une clé, rien ne se passe. L'ordinateur démarre, le ventilo tourne, le HDD est alimenté, mais l'écran reste noir, puis le ventilo ralenti et on n'entend pas le disque dur "gratter" pour chager le système. J'ai aussi essayé en branchant un écran externe, mais ça ne change rien...
Donc ma question : quelqu'un a-t-il déjà eu ce problème sur ce modèle de netbook, et surtout l'a-t-il résolu ?
Pour information, voici la solution trouvée un peu partout sur le net, mais qui ne semble pas fonctionner sur un D255E :
Citation :
Introduction
This is how to resolve the Acer Aspire one Black Screen of Death
Steps (9 total) :
1 - Preparation
To complete this task you will require; The Acer Aspire netbook The power charger for the netbook A Windows based computer with internet access (Not the acer) A 2GB or smaller usb pen Drive
2 - Locate the Acer Aspire one Model
This is usually located on the serial sticker It does not say model number but should be next to the MFG Date: eg. MFG Date: 0809 AOA 150-BW The model is AOA150
3 - Download the correct Driver
Go to Acer website Select support Select Driver Downloads Either type the model number or select via Category Netbook, Aspire One, A0A150 Select the Netbook Select the Bios Tab Download the correct Bios to the computer
4 - Extracting & Setting up New Bios
Once the bios is downloaded go to the location and extract the files Once the files are extracted open the sub folder Dos_flash Rename the "version.fd" to zg5ia32.fd Insert the usb drive into the computer Format the usb memory stick as fat (Not fat32) Once formatted copy the files zg5ia32.fd and FLASHIT.exe to the root of the usb pen drive
5 - Flash the Netbook
With the Netbook off plug in the power cable You should have a green light on the battery symbol and no other lights If the light is orange/red wait for the netbook to charge and the light to go solid green Plug the USB flash drive into any usb port Press and hold the FN key and "Esc" key Now press and hold the power button You should see the power button light start to blink Once this has started to blink you can release the keys. This is now flashing the netbook it can take up to 7 minutes to complete
6 - Netbook Now booted
Once the netbook has finished flashing the bios in should autoboot into windows with the display This should as resolved the issue
7 - Helpful steps to prevent this in the future
One reason this is caused is due to the battery not being calibrated
8 - Calibrate the battery
Make sure the battery is full charged Boot the laptop into windows open the control panel go to power options disable hibernation under the hibernate tab Go to power schemes and select always on Change everything to never for battery and plugged in Go to Alarms tab and turn all the alarms off Now let the battery drain completely till the netbook turns off and will not turn on Once the battery has been drained plug the power adapter into the netbook and wait for the netbook to fully charge and the battery light has gone green. I would recommend to complete the cycle 3 times 9 - Setting Power Options
To save the netbook forcing shutdown change the power options and alarms This is only a guide as an example Go to start Control Panel Power Options Select the Hibernation Tab Enable Hibernation Go to Alarms Tab Set the low battery alarm at 20% Set the action to be display message set the critical battery alarm at 10% Select Actions Set to Display message Set Alarm Action to Hibernate Set the Force stand by or shutdown even if a program stops responding Go to the Power Schemes Set the plugged in options and battery options e.g. Plugged In Turn Off monitor 20Mins Turn Off HDD after 2Hours System Standby Never e.g. Running on Batteries Turn Off monitor 5Mins Turn Off HDD after 30Hours System Standby 1Hour
Apply
Conclusion
This should now stop the Acer requiring the Bios fix
I would recommend you run the battery calibration once a month
|
Message édité par Hyades le 15-10-2015 à 20:46:02