Je précises qu'il n'y à que le boitier et son alim ainsi que la carte mère dont voiçi les specs que m'a filé un pote qui bosses à  Dell.
Préférence près de chez moi sans vouloir imiter les parisiens mais un boitier par la poste surtout pour ce qu'il vaut celui-là c'est trop cher.
 
-----------
 
General  
--------
Microprocessor type Intel® Pentium® with MMX? technology  
Microprocessor speeds 166/66 MHz
200/66 MHz  
233/66 MHz  
Internal cache 32 KB  
External cache 512 KB  
Math coprocessor internal to microprocessor  
Microprocessor socket ZIF  
 
System Information  
--------------------
System chip set Intel 430VX PCIset  
Data bus width 64 bits  
Address bus width 32 bits  
DMA channels <http://docs.euro.dell.com/docs/systems/dter2/dma.htm> 7  
Timers 3  
Interrupt levels <http://docs.euro.dell.com/docs/systems/dter2/irq.htm> 15  
Flash EPROM 128 KB, AMI-based  
I/O controller chip SMC FDC37C93xFR  
 
Expansion Bus  
---------------
Bus type ISA and PCI  
ISA expansion-card connectors 3 full-length slots (1 connector shares a card-slot opening with a PCI connector)  
PCI expansion-card connectors 4 full-length slots (1 connector shares a card-slot opening with an ISA connector)  
Bus mastering all PCI slots support PCI bus master cards; integrated bus mastering IDE on the PCI bus (ATA specifications-compliant) with 2 connectors/4-device support; both channels support 528-MB or greater hard-disk drives (LBA mode) and multisector reads and writes  
ISA bus speed 8.25 MHz  
ISA data transfer rate 1 Mbit/sec  
PCI bus speed 33 MHz  
PCI data transfer rate 70 MB/sec  
Plug and Play revision 1.0A  
PCI connector data width 32-bit  
 
Memory  
---------
DIMM sockets 2  
DIMM capacities 16- and 32-MB (SDRAM)  
DIMM type 64-bit  
Minimum RAM 32 MB  
Maximum RAM 64 MB  
Memory access time 9.5 ns rated @ 50pf; Intel 66-MHz SDRAM V1.X-compliant  
External cache 512-KB single-bank pipelined burst SRAM  
BIOS address F0000h  
DIMMs buffered or unbuffered unbuffered  
Supports 2 or 4 clock cycles both  
DIMM voltage 3.3 V  
NOTES: The only 32-MB SDRAM DIMMs validated for use in this computer are the following:  
Samsung KMM366S403AT1-G2  
Hitachi HB526A464EN-10  
Samsung KMM366S403AT-G2  
Toshiba THMY644021AEG-12A  
 
The system may not recognize other 32-MB SDRAM DIMMs and may fail POST.  
 
When the system memory size is increased above 64 MB in a system with the Intel® Pentium® VX chip set, the system slows down. The problem is the cache limits of the chip set. The second-level (L2) cache can store (cache) memory only for accesses made in the lower 64 MB of main memory due to the size of the cache tag. If more than 64 MB is installed in the system, any memory access to data above the 64 MB is not cached. The system runs cacheless for memory accesses. The Microsoft® Windows® operating system uses pages of memory throughout the entire memory space so some accesses fall above the 64-MB region, which causes a decrease in performance. In effect, instead of getting a performance gain for adding more memory to a base 64-MB system, in many instances the performance is slower.  
 
Additionally, many games that use MS-DOS® extenders are loaded at the top of the memory space so all accesses to the code are cacheless.
 
 
Drives  
-------
Externally accessible bays (2) 5.25-inch bays
(3) 3.5-inch bays (mini tower systems)
(2) 3.5-inch bays (desktop systems, Europe only)  
Internally accessible bays (2) 3.5-inch bays  
 
Ports  
------
Externally Accessible:  
Serial (DTE)
9-pin connector (16550A-compatible, 16-byte buffer)  
Parallel
25-hole connector (bidirectional) (AT-, PS/2-, ECP-compatible)  
Video
15-hole connector on video card  
PS/2-style keyboard
6-pin mini-DIN  
PS/2-compatible mouse
6-pin mini-DIN  
USB
2 USB 1.0-compliant connectors  
MIDI/game
15-pin connector  
Line in (input)
miniature jack  
Line out/speaker out (output)
miniature jack  
Microphone
miniature jack  
Internally Accessible:  
Primary EIDE1 (hard-disk drives only)  
40-pin connector on local PCI bus  
Secondary EIDE2 (EIDE devices)  
40-pin connector on local PCI bus  
Diskette drive
34-pin connector  
Wave-table expansion card
8-pin connector  
1 Provides support for LBA and ECSH translation modes  
2 Provides support for ATAPI and PIO mode 3 and 4 devices  
 
Audio
------
Model Creative Labs Vibra16
UPG to AWE32 via expansion card  
Chip set Vibra16c  
Frequency response 53 Hz to 20 KHz (line out)  
Signal-to-noise ratio 75 dB (line out)  
Total harmonic distortion 0.02% (line out)  
Output power .09 W/channel (32-ohm headphones as load)  
Maximum output signal 2 Vrms  
Microphone impedance 3.2 K  
Microphone input range 5 to 30 mVpp  
Line-in impedance 10 K  
Line-in input range 0 to 2 Vrms  
CD audio-in impedance 27.6 K  
I/O mapping:  
Audio
220-233h, 240-253h, 260-273h, 280-293h  
Joystick
200-207h  
OPL3
388-38Bh  
MPU-401UART
300-301h, 330-331h  
 
Video  
------
Video type no on-board video; PCI video card in expansion-card slot (see manufacturer's specifications)  
 
Key Combinations  
<Ctrl><Alt><Del>* restarts (reboots) the computer  
*There are no hot-key combinations for entering the system setup program. Press <Del> when prompted.  
 
Power  
DC power supply:  
Wattage
200W  
Voltage
90 to 135 V at 60 Hz or
180 to 265 V at 50 Hz  
Battery 3.0-V, coin-cell CR2032-type

Manque plus qu'un ptit 233 MMX et 64 sdram et hop là !
 

oui je suis prenneur pour la carte mere  
on peut mettre de la edo