Voici ce qu'il y a de noter comme aide:
Si quelqu'un peut m'aider avec ce texte.
:::Configuring Email:::
Configuring Email is a little trickier, so make sure you have the web browser
proxy working properly before doing this. You now have two methods, one is to
use the method described below, which can sometimes be a pain to get working,
the other is to just use Socks4 and a client that either supports it, or works
with Socksify (refer to the section below about Socks).
If you want to try the normal method, open up the 'Configure' menu, and select
'Configure Email Alias's'; you'll be presented with the email account
configuration area. Select 'Add' from the menu; this is where you will enter
in the servers you check your email from... First, you need to enter the email
address that people send messages to, like 'bob@domain.com'. Next, you need to
set the POP3 server, which is where your email program goes when it receives
email; normally this will be something along the lines of 'pop3.domain.com' or
'mail.domain.com'. Finally, you need to set the SMTP server, which is what
your emails are sent through, which in the above example could be something
like 'smtp.domain.com'. Now, it's important to note that not every service uses
two different names for the server, you might check both POP3 and SMTP from
the same server; in this case you can just leave the SMTP field blank. That's
it for the proxy! Now you have added email support for this particular user.
Now you need to set up the configuration of the email program you use; this
varies from program to program, but you need to go to wherever you enter both
the servers that the program checks. Now, instead of entering 'mail.domain.com'
or whatever your mailserver is, you'll enter the IP address of your proxy
server, such as '10.0.0.1'. It's important to note that you won't need to
change the port settings in the email program, since the proxy uses the same
ports a normal server would. Also, you will set both the SMTP, as well as the
POP3 servers to the same IP address; the proxy will make sure they get to the
correct place. Now, let's check out your configuration; try sending an email
to yourself... If everything is configured properly, they you should be good
to go!
One more thing to note about email; it will only support using a certain
username once; for example, you can't have bill@homecomputer.com and
bill@workcomputer.com; but you can have bill@homecomputer.com and sue@another.com.
In most cases this shouldn't be a problem for users, since most people have
different usernames for each account... The reason I decided to do it this way
was to make it easier to configure email programs, but there's always a minus
to each plus.
One other note about email; if you have a different login name than email name
(like you check mail by using the login name bill, but your email address is
billyg@computer.com), then you'll need to create TWO alias in the email section;
one just like normal, using billyg@computer.com, and one using the login name
in place of the email name (so bill@computer.com).
