Some chips are also accessible through the ISA bus. ISA probes are typically a bit more dangerous, as we have to write to I/O ports to do this. Do you want to scan the ISA bus? (YES/no): y  
Probing for `National Semiconductor LM78'
Trying address 0x0290... Failed!
 
Probing for `National Semiconductor LM78-J'
Trying address 0x0290... Failed!
 
Probing for `National Semiconductor LM79'
Trying address 0x0290... Failed!
 
Probing for `Winbond W83781D'
Trying address 0x0290... Failed!
 
Probing for `Winbond W83782D'
Trying address 0x0290... Failed!
 
Probing for `Winbond W83627HF'
Trying address 0x0290... Failed!
 
Probing for `Winbond W83697HF'
Trying address 0x0290... Failed!
 
Probing for `Silicon Integrated Systems SIS5595'
Trying general detect... Failed!
 
Probing for `VIA Technologies VT82C686 Integrated Sensors'
Trying general detect... Failed!
 
Probing for `VIA Technologies VT8231 Integrated Sensors'
Trying general detect... Failed!
 
Probing for `ITE IT8705F / IT8712F / SiS 950'
Trying address 0x0290... Failed!
 
Probing for `IPMI BMC KCS'
Trying address 0x0ca0... Failed!
 
Probing for `IPMI BMC SMIC'
Trying address 0x0ca8... Failed!
.
.
.
I will now generate the commands needed to load the I2C modules.
Sometimes, a chip is available both through the ISA bus and an I2C bus.
ISA bus access is faster, but you need to load an additional driver module for it. If you have the choice, do you want to use the ISA bus or the I2C/SMBus (ISA/smbus)?  
 
WARNING! If you have some things built into your kernel, the below list will contain too many modules. Skip the appropriate ones!
To load everything that is needed, add this to some /etc/rc* file:
 
#----cut here----
# I2C adapter drivers
# I2C chip drivers
#----cut here----
 
 
To make the sensors modules behave correctly, add these lines to either /etc/modules.conf or /etc/conf.modules:
 
#----cut here----
# I2C module options
alias char-major-89 i2c-dev
#----cut here----