Suite à une question posée au support NEC concernant un pbm de gravure de DVD-R, voici leur réponse;
Elle est dense mais peut sans doute servir à d'autres, et en + si on pouvait m'aider à comprendre 2 ou 3 trucs ...
dear customer,
Pls. note the following steps:
It is recommend that device should be connected to secondary IDE port as
master. Dont use fast ATA 133/166/233 and 266, unit should connected with
delivered UDMA-2 cable(40pin)
First deinstall all your burnersoftware(s), also clean registry*.
(*it is recommend to use cleaning tools from NERO:
General Clean Tool http://www.nero.com/en/631940828445001.html
Registry Checker and DriverClean tool
http://www.nero.com/en/631938356417810.html
InCD Clean Tool http://www.nero.com/en/631938356212815.html
Nero 5 Clean Toolnero clean tool
http://www.nero.com/en/631938364095950.html)
Install actual mainboard driver (Busmaster/ Chipset driver). contact in
this case manufacturer of your mainboard. For test you can also try to burn
without DMA mode, (only possible under Windows XP and Windows 2000) in the
device manager - "IDE ATA/ ATAPI controllers", you can switch from DMA to
PIO mode. If you got problems with NFORCE Chipset drivers, you should
better reinstall MS standard IDE drivers.
More than one installed burnersoftwares can cause problems (**some
softwares replace ASPI driver by their own! ) so install only one,
especially actual trial release of NERO [ http://www.nero.com ] and check
burn project again.
**If needed, install actual ASPI Driver (contact manufacturer of your
burnersoftware e.g. www.nero.com)
Use our recommended medias, with other medias there`s no guarantee, they
will be written correctly and with maximum speed.
[http://193.141.139.226/softwareoverview2.php?id=557]
For Problems with InCD, pls. contact Nero support. Be informed, Mt.Rainier
(e.g. directCD) is not supported!
You can deactivate for test (only with Windows XP) "IMAPI CD-Burning COM
Service", go to menu "start" > "settings" > "administration" > "services",
search "IMAPI CD-Burning COM Service", rightclick and deactivate
"starttyp".
The option "Book Type DvD-Rom" (only in NERO 6.3.x under "burn tab" or in
NERO Express 6.3.x under "more-button" available) must be deactivated
before starting burn procedure, this feature isn`t integrated on the
hardwareside by all NEC burners, so burn procedure will fail if activated!
Pls. be informed for problems with "external" USB and FireWire versions
(OEM) of this burner, you have to contact manufacturer of them for service
and support. The retail version of ND-Series Burner is recommend for
"internal" usage.
Pls. be also informed, that firmware updates for DvD Burner ND-Series will
not solve problems in conjunction with some burnersoftwares caused by
missing support on the softwareside by their manufacturers.Firmwareupdates
usually adds only new media information.
If this steps won`t solve your problems, pls. claim unit at your dealer as
defect.
Au fait si qqu'un peut m'aider à reconnaître un cable UDMA-2 cable(40pin) ??
Je ne comprend pas non plus le conseil de passer en mode PIO ? à une époque, C ce qui rendait mon graveur de CD super lent ?
ça donne koi en français l'option "Book Type DvD-Rom" de NERO ?
Merci.
